A packet of about 0.6KG
inside is 100pcs
A4 size, Laser printer is used to map the PCB map to the smooth side and apply it to the copper plate, and put it into the fast plate making machine or the electric iron to transfer to the.DIY heat transfer paper.
Production of printed circuit boards, is often a matter of electronic enthusiasts headache, many electronic enthusiasts to produce a printed circuit board, often using paint trace plate, knife carving, adhesive paste etc. amateur production method, slow, and difficult to produce high quality of printed circuit board. Production of printed circuit boards and even become many beginners enter electronic hall &ldquo &rdquo way;.
The circuit board is made of heat transfer method, the circuit board is painted graphics, printed by laser printer in thermal transfer paper, then transfer paper covered in copper clad plate, heated, melted toner completely adsorbed on the copper clad plate, etc. after cooling off transfer paper, you can see the circuit board graphics have been transfer to the copper clad plate, black anti-corrosion layer, which is PCB map we want, and finally corrosion, can be obtained by the PCB board we want.
Heating tools used in the manufacturing process of electric iron or plastic. The transfer paper is a special hot transfer paper for making the circuit board. It has the following advantages: a circuit board.
1 The precision of plate making is high.
2. The cost of plate making is low;
3. The speed of plate making is fast.
4. A double-sided plate can be made.
1 the circuit board of the circuit board is printed with the laser printer to the surface of the heat transfer paper.
2, use the plate making machine to 150-180 degrees Celsius. The side of the thermal transfer paper is printed on the copper coated plate to transfer. The iron can be used instead of the plate making machine to transfer manually.
After 3 printing, the transfer paper was removed and the copper clad plate was put into the iron chloride solution for corrosion.
4 finally clean the carbon powder on the circuit board with gasoline, or flush out the carbon in water with water.
- Brand Name: TailKuKe
- DIY Supplies: Electrical